DNVGL.com

Breadcrumbs

Ballast water management and port state control – checklist for preparation of PSC inspections

The international Ballast Water Management Convention (BWMC) came into force on 8 September 2017. In Paris MoU alone, the Port State Control (PSC) issued more than 70 deficiencies regarding BWM in the last four months of 2017; worldwide more than 160 deficiencies were identified up to March 2018. This PSC news provides you with an overview of the main categories of deficiencies raised during the first seven months of BWMC entering into force and provides a checklist for preparation of PSC inspections regarding BWM systems, their operation and maintenance.
  • Published:
  • Author:
  • Keywords: PSC, Maritime
Ballast Water Management

The following list contains the most frequent findings that have been detected by PSC, which should be focused on:

  • About one-third of BWM-related deficiencies are for incorrect, not properly filled-out or missing entries of all ballast water movements (inboard, treatment, circulation, discharge), or the BWM record book itself is missing.
  • About 25 percent of the deficiencies are the result of incorrect ballast water exchange; either the ballast water was not exchanged at all or the amount of water exchanged was insufficient.
  • The BWM plan was not approved, incorrect or missing in 25 cases. In this respect, attention should be paid to the re-approval of the BWM plan after change of flag.
  • Lack of familiarization and training of the crew has a significant impact on the handling of ballast water, according to the BWMC.

In addition to these findings, the timeline for implementation of the D-2 standard and respective actions for installation of approved treatment plants, as required by the convention, need to be observed.

DNV GL has developed a common checklist (see in the full article for download) for supporting your preparation for PSC inspections with regards to the BWMC.

Compliance with the BWMC is not limited to verification during PSC inspections, however. In national waters, other local authori¬ties (e.g. water police, harbour master) may detect violations to this convention and might impose penalties or initiate follow-up by the local PSC.

Recommendations

  • Familiarize yourself with the requirements of the Ballast Water Management Convention
  • Utilize the enclosed PSC BWM checklist for preparation on board 
  • Inform and train the crew

References

2018. gada 3. maijs

Practical advice for IMO DCS data collection starting 1 january 2019

Both EU MRV (Monitoring, Reporting and Verification) and IMO DCS (Data Collection System) requirements are mandatory, and are the first step in a process to collect and analyse CO2 emission data for the shipping industry. EU MRV data collection already started from 1 January 2018, while IMO DCS data collection on fuel consumption to comply with the IMO DCS regulations starts 1 January 2019. This statutory news provides practical advice on IMO DCS compliance.

  • Maritime
2018. gada 21. marts

Ballast water management and port state control – checklist for preparation of PSC inspections

The international Ballast Water Management Convention (BWMC) came into force on 8 September 2017. In Paris MoU alone, the Port State Control (PSC) issued more than 70 deficiencies regarding BWM in the last four months of 2017; worldwide more than 160 deficiencies were identified up to March 2018. This PSC news provides you with an overview of the main categories of deficiencies raised during the first seven months of BWMC entering into force and provides a checklist for preparation of PSC inspections regarding BWM systems, their operation and maintenance.

  • Maritime
2018. gada 20. februāris

Shaft alignment and propeller shaft aft bearing performance – recent trends call for action

Recent experience reflects concerns on propeller shaft aft bearing performance on some oil lubricated installations, e.g. ships with single stern tube bearing, during turning conditions involving hard-over steering angles in the upper speed range (MCR). This also coincides with evolving trends comprising of larger and heavier propellers operating at a lower RPM and different types of stern tube lubricants. This technical news aims to elaborate the basic logic, criteria and recommendations associated with propeller shaft aft bearing performance.

  • Maritime
2018. gada 24. janvāris

Cold conditions call for extraordinary measures for ships, equipment and crew

Canada and other areas close to the Arctic are currently experiencing extremely low temperatures, and owners calling at ports in these areas are obliged to prepare accordingly. This includes paying particular attention to safety and navigation-related equipment which may be damaged or impeded from working properly under such conditions. This PSC news summarizes the most important measures to be assessed for cold climate navigation.

  • Maritime
View all